The tool status is monitored by evaluating the load on the various axis drive motors. Excessive loads point to wear or broken tools. Too low a load indicates a tool is missing.
A coolant pressure of 25/40/60/80 bar can be set as necessary. This enables coolant-fed drilling and milling tools to be used to their best advantage.
The Sinumerik 840D sl with Operate user interface is ergonomically located at EMCO on the left of the work area and can be swivelled approx. 120° and - with the Hyperturn 200 - also be moved. Shopturn dialog programming, RJ45 and a 230 volt outlet on the side are included in the standard version as well as a robust OP19“ touchscreen for industrial use.
For increased productivity and efficiency in production.
EMCONNECT facilitates easy access to digital production – all important information and systems are accessed centrally on the machine. The familiar NC control and hence the familiar operation of the machine remain unchanged.
A clear and compact overview of the machine state, the machine data and the operating mode is available at a glance thanks to the emcoNNECT Dashboard. The hardware basis of the EMCONNECT control centre is a 22“ multi-touch display teamed with an industrial PC and a keyboard including HMI hotkeys for easy and intuitive operation via a user interface optimised for touchscreen use.
Included as standard equipment in the Siemens machine version (Siemens 840D sl).
The sensational CAM solution for turning and turning/milling. ESPRIT greatly simplifies the programming of complex machining processes and significantly reduces set-up times.
Using CPS the result is 100 % production reliability, up to 80 % shorter set-up times and an enormous increase in productivity and operating efficiency.